winfai WROTE:It compose of 3 different board. the data output is via USB cable. so i am thinking of using one SKXBEE connect with the tower system above.... But the program is i can't program or in your work, translate to action. the SKXBEE can either use microcontroller or USB cable at one time and it can't use simultaneously. what can i do?? I have another question, the SKXBEE that use with computer will not require any programming, just use X-CTU to configure???
is USB the only output? It is not possible to connect SKXBee to the USB port of that board, because USB is device and host communication. A USB mouse cannot connect to a USB keyboard, same concept applied to other USB devices. Though there is exception, but it requires more complex hardware. I am seeing there is other output from the link you paste, there are RS232 output and etc.
as for another question, it depends on what you need on computer, X-CTU allow you to configure the XBee easily and have a Terminal window to show the data received easily. If the data you need is raw, it should be fine to use X-CTU or HyperTerminal or other terminal program. If you need to process the data from ECG, you will need programming.
Looking at your description and the board you are using, there are much more work to be done than just hooking up the modules, you will need to understand the fundamental of electronics and communication. Good luck and work hard.