Dear all,
I have open a thread recently but i didn't get the answer of it, so i open this thread to provide more update for my problem.. currently i try to send the serial port data (DB9) which baud rate at 115200 , using SKXBEE... I have two SKXBEE work as receiver and transmitter.... Max232 to convert the RS232 data to TTL, 5V to transmit via SKXBEE...
I have set all the address (there are three such as destination, etc) to zero and set the baud rate to 115200.... I have set same thing for both SKXBEE.... Following is the process flow
serial port DB9>>>RS232 signal at 115200 baud rate>> MAX232 circuit>>TTL signal>>SKXBEE
I can't get any signal transmitted, there are no light for TX and RX for both SKXBEE, no activity at all.... Can someone help to advice what has happening???? Is the baud rate too less or i need to set higher for it??? I have check many time for the MAX232 configuration and there is no problem.... My MAX232 circuit look exactly like the following image
http://www.google.com.my/imglanding?q=r ... 53&bih=359