Cytron Technical Forum


http://forum.cytron.io/

PR20 problem

http://forum.cytron.io/viewtopic.php?f=10&t=10944

Page 1 of 1

PR20 problem

PostPosted: Mon Apr 04, 2011 1:51 am
by aket88
i have bought PR20 DIY kit and read through the document PR20_DD.pdf
i have assemble all the component and recheck the polarity of led and diode b4 solder
im now having problem how to use this diy kit
for example i want to press sw2 on input board to light up the led2 on output board. this is not happening
for x-ctu, i configure accordingly as told in the document
can anyone please help me? thx in advance

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 12:23 pm
by joliza
Have you set the mini jumper according to I/O defined..?

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 12:38 pm
by aket88
yes
4 example, on the input board, i have to jumper on jp2 while on the output board, i have to jumper on led2.right?

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 2:06 pm
by sich
Did you set the jumpers on both boards correctly? Please follow closely to the Detail Description.

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 4:14 pm
by aket88
i've follow directly from that..
however in the document, it doesnt tell how to configure the jumper..

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 7:20 pm
by sich
Please look at Figure 7 in page 4. The explanation is under the figure.

Re: PR20 problem

PostPosted: Mon Apr 04, 2011 9:33 pm
by aket88
yes,i have refer to page 7 as u said
is there any step missing in the document?
becos i program xbee using x-ctu following the step provided in the document
and in the end it doesnt not function
actually im beginner to xbee.. :geek:

Re: PR20 problem

PostPosted: Thu Apr 07, 2011 9:49 pm
by ober
Hi, can you capture a photo of both board and share it here?