Cytron Technical Forum

hye.. i have the xbee starter kid.. and already get bored in implementing it.. haha.. now i want change my xbee module to bluetooth bee.. i realize at the pcb board, it use plated through hole so the soldering is very tight. is that posible to remove the xbee module form the pcb without damaging both? i mean the pcb and xbee module. Does anyone tried before?

Er.... never try before removing the XBee module from SKXBee if that is what you mean.

Looking at the Bluetooth Bee module, the pin seem to be compatible with XBee, should be fine. But taking the Xbee off from the SKXBee I might think twice. I would go for getting another SKXbee without module