Cytron Technical Forum

I am using Digimesh 2.4 firmware 8062 , trying to create a network that support multihop and multipoint.

All the xbee module will be connected to a laptop by the SKXBEE, i need help configuring the module ,so each module can send and read data.I am using the xctu software to send and read the data.

Never use Mesh network before , so what is the configuration needed? If you use X-CTU, refer to the datasheet or the mesh networking manual you should able to get the configuration right?

Just setup all XBee with same ID. I don't know detail, but with same ATMY and ATDL. If 2 XBee can communicate, the multipoint wireless is only depends on microcontroller programming.