i use SKKCA-21 for transmitting the ASCII code to control two motors direction
w forward 1010
s backward 0101
a left 1000
d right 0010
x stop 0000
the connection is up...in bypass mode...sending 'w' and the motors is moving forward...but when sending 's' the motors doesn't move and the connection is down
AT-ZV ConnectionUp
AT-ZV -BypassMode-
w
s
AT-ZV -CommandMode-
AT-ZV ConnectionDown
i coudn't figure it out why? but b4 trying with the motor i use 4 LEDs...the LEDs are fine... so what happen with the motor?
plus when the motor is block from moving ...the connection is down 2...