motor control through SKKCA-21 connection down

Bluetooth, XBee, RF......

motor control through SKKCA-21 connection down

Postby thumkh » Sat Mar 24, 2012 7:54 pm

i use SKKCA-21 for transmitting the ASCII code to control two motors direction
w forward 1010
s backward 0101
a left 1000
d right 0010
x stop 0000

the connection is up...in bypass mode...sending 'w' and the motors is moving forward...but when sending 's' the motors doesn't move and the connection is down

AT-ZV ConnectionUp
AT-ZV -BypassMode-

w

s

AT-ZV -CommandMode-
AT-ZV ConnectionDown


i coudn't figure it out why? but b4 trying with the motor i use 4 LEDs...the LEDs are fine... so what happen with the motor?

plus when the motor is block from moving ...the connection is down 2...
thumkh
Newbie
 
Posts: 11
Joined: Sun Mar 04, 2012 10:09 pm

Re: motor control through SKKCA-21 connection down

Postby Idris » Sat Mar 24, 2012 10:17 pm

Maybe the current draw higher when motor is blocked which cause the system reset. For reverse, you need to troubleshoot the hardware. Try change the motor wires polarity and press forward, just want to make sure the motor can 'reverse'. If not OK, then the reason same as motor blocked. If that OK, then check the hardware part at motor driver. What you need is check, check and check, that is called TROUBLESHOOT. :)
Cytron Technologies invest time and resources providing tutorial, training and support for STEM education and maker movement. We need your support by purchasing products from Cytron Technologies. Thanks.
http://www.cytron.com.my
User avatar
Idris
Moderator
 
Posts: 409
Joined: Thu Mar 22, 2012 5:28 pm
Location: Pulau Pinang


Return to Wireless Device

Who is online

Users browsing this forum: No registered users and 13 guests

cron