i have exactly follow the exact steps in project 14 provided by cytron.
transmitter = xbee series1 on shield attached to arduino
receiver = skxbee series1
i have already programmed the transmitter with DL = 1000 and MY = 1001, and the receiver vice versa.
before programming this, i put the jumper in usb mode and wired the reset to ground instead of removing the ATMEL chip.
when tested by typing at the terminal inside xctu, both transceiver acted as they were supposed to be. (e.g type 123 at transmitter in blue colour, 123 can be seen at receiver in red.)
the thing is, when the temperature circuit is connected to the arduino, the xbee suddenly could connect to xctu (modem cant be recognized by xctu), but continously transmit data inside the terminal at the transmitter side, BUT (of of course) cant be detected at the receiver. i have already put the jumper in xbee mode when try to transmit. and remove the reset to ground connection.
can somebody help me ? i need solution ASAP ! gladly appreciate any help ! (both xbee version 10EC in xctu )