remote control

Bluetooth, XBee, RF......

remote control

Postby yau9264 » Thu Sep 05, 2013 11:05 pm

i am using the ht12d and e to make a remote control.
the a0-a7 of both ht12d and e is same, the d0-d3 of encoder is connect to switch to ground. te connect to gnd
Rsoc of 12e is 1M and 12d is 33k
d0-d3 of 12d is connect the led
then i connect the pin17 of 12e to pin14 of 12d
but it does'nt work, pls help me
thank you :oops:
Posts: 1
Joined: Mon Sep 02, 2013 12:26 pm

Re: remote control

Postby ober » Sat Sep 07, 2013 8:40 pm

A clear photo will help a lot.
Ober Choo
Cytron Technologies Sdn Bhd
User avatar
Posts: 1447
Joined: Wed Apr 15, 2009 1:03 pm

Re: remote control

Postby ABSF » Sun Sep 08, 2013 11:05 pm

yau9264 WROTE:Rsoc of 12e is 1M and 12d is 33k

According to the datasheet, the decoder osc freq. is 50x the encoder osc freq. Since you're using 1M for encoder which is 3KHz at 5V. So the decoder osc freq should be 150KHz at 5V which is 51K NOT 33K.

Try using 51K and see if it works...

The next war will determine NOT who is right BUT what is left.
User avatar
Posts: 810
Joined: Wed Nov 10, 2010 9:32 am
Location: E Malaysia

Return to Wireless Device

Who is online

Users browsing this forum: No registered users and 3 guests