Cytron Technical Forum


http://forum.cytron.io/

View data from arduino through X-CTU

http://forum.cytron.io/viewtopic.php?f=10&t=12446

Page 1 of 1

View data from arduino through X-CTU

PostPosted: Sat Apr 19, 2014 6:34 pm
by Aswad.hehe
Hello.. just want to ask is that possible if i view the data from arduino+xbee through 'terminal' section on x-ctu?? ive done before by using arduino+xbee where i can view the data through arduino+xbee+computer on serial monitor on arduino IDE.. but this time i just use the single xbee connected to the computer..the data is kind of some word to state the condition ; Relay OFF, Relay ON..

Re: View data from arduino through X-CTU

PostPosted: Mon Apr 21, 2014 10:36 am
by Idris
Hi Aswad.hehe

Aswad.hehe WROTE:Hello.. just want to ask is that possible if i view the data from arduino+xbee through 'terminal' section on x-ctu?? ive done before by using arduino+xbee where i can view the data through arduino+xbee+computer on serial monitor on arduino IDE.. but this time i just use the single xbee connected to the computer..the data is kind of some word to state the condition ; Relay OFF, Relay ON..


Sorry, I'm not really clear about the question. But I think, might be possible.