Cytron Technical Forum

Dear Cytron Technical Forum,
I got "Cytron Bluetooth Module" online from cytron, and when I test them according to the tutorial by using "XBee Starter Kit without module" , using AT commands and set both switches to AT, the first one it works fine without any problem but, the second one dose not shows any response, as shown in photos Help me Please. Thank you

Hi Ali_Challenger,

Did you use the same setting on HyperTerminal for 2nd BlueBee?

Steps to AT command (default)
STEP 1:
1. Set Mode switch to AT.
2. Power up the module.
Result: You can configure the BlueBee with baudrate 38400.
STEP 2:
1. Power up the module.
2. Set Mode switch to AT.
Result: You can configure the BlueBee with baudrate 9600.

Hi Idris, thank you for the quick reply
Yes I did same and changed the baudrate to (110,300,1200,2400,4800,9600,19200,38400,57600,115200) also didn't get any response, and just tried with X-CTU also same no response.

Is the slide switch being pushed to AT?

Yes the switch is at "AT" and the status LED blinking slowly.

In that case, you can fill up the Technical Support form (link). Our Technical Support team will follow up on your problem.

Thank you so much I will fill up the form now.

Thank you CYTRON crew I received the Bluetooth Module and it works perfectly.

Good evening:
Regarding to the useful tutorial by CYTRON "Connect Android Bluetooth to BlueBee",
can you please tell me what is the ARDUINO sketch and the AT command settings for the BlueBee. in order to complete the tutorial.

Thanks.

Hi Ali_Challenger, that tutorial shows how to connect Android apps to BlueBee through bluetooth medium. In order to see the data just open the terminal with selected COM port. Then, from the data, you can program your microcontroller to suit with your project application.