Im using Xbee s1 with cytron xbee shield on arduino uno. (TX:USB, RX:USB)
I need to setup the Xbee setting using arduino coding without XCTU or Putty (not using laptop).
After Serial.print("+++"); ,the expecting "ok" is not showing up.
From arduino tutorial from arduino.cc .
To configure it from the Arduino board, you'll need to have the switch in the Micro position(Arduino Wireless SD shield).
http://arduino.cc/en/Guide/ArduinoWirelessShield
So, which TX and RX pins on shield should i connect to configure xbee from arduino board?
thanks.