PR8 with Servo Motor
Posted: Sun Nov 20, 2011 1:07 amHai all,
I would like to know, can this DIY connected to the servo motor using the board?
Thanks
I would like to know, can this DIY connected to the servo motor using the board?
Thanks
Cytron Technical Forum
PR8 with Servo Motor
Page 1 of 1
Posted: Sun Nov 20, 2011 1:07 amRe: PR8 with Servo Motor
Posted: Tue Nov 22, 2011 8:59 pmWell, is possible. you need to make sure there is available pin and depends which servo motor you want to use, current need to be sufficient as servo motor will draw quite some current when it rotate.
Re: PR8 with Servo Motor
Posted: Fri Nov 25, 2011 9:20 amLooking through PR8 schematic, I din study it, sorry.... is not my project 
.
It seem there are still left RA4, RA5, RC5 and RC6 is not in used by the original design. You can utilize those pins to drive RC servo. Yet, as highlighted by ober, you will need to makesure the supply is sufficient for RC servo and also circuit.
.It seem there are still left RA4, RA5, RC5 and RC6 is not in used by the original design. You can utilize those pins to drive RC servo. Yet, as highlighted by ober, you will need to makesure the supply is sufficient for RC servo and also circuit.