Page 1 of 1
RFID
Posted:
Sun May 04, 2014 3:34 pmby nurulrusli
HELLO.. my capacitor c23 in board rfid MiFare actually broken.. did i need to buy a new one rfid or just buy the new capacitor and solder it?
Re: RFID
Posted:
Mon May 05, 2014 12:58 amby yonghui
the board still working after the cap broke?
u know the value of the cap?
Re: RFID
Posted:
Mon May 05, 2014 7:19 amby nurulrusli
I not sure the value bcause the cap is too tiny. mybe the number in the cap is 106k , 74JJ0.. it will effect the board or not?
Re: RFID
Posted:
Mon May 05, 2014 7:28 amby nurulrusli
i already done the installation for the rfid with uart, but it error.
Re: RFID
Posted:
Tue May 06, 2014 9:34 amby ober
Are you referring to CR038 Mifare RFID Reader/Writer? If so, can you share this information?
- Can you please capture a photo of the Reader board, to show which capacitor is burnt? And how does the capacitor burn? When you power it up the 1st time? Or it actually burnt when you receive it?
- How do you interface it with your computer/laptop? Using UC00A? Have you install the driver for it? Also it will be good if you can share the hardware setup photo with the USB to UART converter and also the reader.
- Have you check the com port number?
Re: RFID
Posted:
Tue May 06, 2014 1:55 pmby nurulrusli
yup..i referring the reader step.. my com port is 4. actually my capacitor is not burn but it is broke, i already instal the driver, but am nt too sure..
Re: RFID
Posted:
Tue May 06, 2014 9:23 pmby ober
It seem to be correct. Please do fill in the support form and our technical team will follow up with you.
http://www.cytron.com.my/support.php
Re: RFID
Posted:
Tue Dec 06, 2016 12:42 pmby lantran
mybe the number in the cap is 106k