Page 1 of 1

Cutting Donut Board

PostPosted: Mon Aug 22, 2011 4:13 am
by Ville
Hello,

I would like to ask a little silly question,

I would like to cut a donut board into smaller pieces.
Is there any "cheap" way cut it cleanly as I dont have any pcb cutter.

thanks for any advise ^^

Re: Cutting Donut Board

PostPosted: Mon Aug 22, 2011 10:05 am
by yonghui
hi,


i always use normal cutter to cut down some guides on both side, then break it carefully by force


rgds,
yh

Re: Cutting Donut Board

PostPosted: Mon Aug 22, 2011 10:45 am
by hyng
Yes, agree with yh method. Using normal box cutter will do. :)

Re: Cutting Donut Board

PostPosted: Mon Mar 06, 2017 8:29 am
by paracetamol
Pretty much agree with the advices given above. Just cut it carefully, don't shake your hand. That will do, try it mate.