Trollingh motor with Cytron 30A DC Motor Driver

LED Blinking, Walking with Cytron Servo, Displaying RFID, Multi-function Mobile Robot......

Trollingh motor with Cytron 30A DC Motor Driver

Postby moralesj » Fri Sep 07, 2018 9:54 am

HI do any one know if i can add a diode in from of the power source terminal to stop any voltage leak back to some current sensor that will be place in front of the controller . see attached file

below is there current sensor and temp sensor that i am trying to add
Quanum 2.4Ghz Telemetry System Temp/Amp Add-On

https://hobbyking.com/en_us/quanum-2-4g ... dd-on.html
Attachments
thumbnail_image.png
moralesj
Fledgling
 
Posts: 1
Joined: Fri Sep 07, 2018 9:34 am

Re: Trollingh motor with Cytron 30A DC Motor Driver

Postby ober » Sun Sep 09, 2018 6:37 am

Two things:

1. Normally we measure current at Motor side, not the power source.
2. The diode to prevent flyback power will need to be high current because in normal condition, it will need to allow current to flow to the driver, right?

Actually the current sensor can accept current flow from both direction, so there is no need to prevent current to flow back to battery.

And since you are using RC (Radio Control), just want to remind that MD30C does not take RC signal as control input, you will need some control to convert RC into standard PWM.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1378
Joined: Wed Apr 15, 2009 1:03 pm


Return to DIY Project Set

Who is online

Users browsing this forum: No registered users and 1 guest