Hi,
I have just assembled PR20 board and downloaded X-CTU, USB Serial Converter Driver. Right now i'm facing below problems:
1. 1st board no respond at all when connected to UC00A. Led for 3.3V and xbee do not turn on.
2. 2nd board 3.3V and xbee Led turn on but turned off while communicating with UC00A and X CTU.
My X-CTU and device driver are working since i am able to communicate with my other SKXBee module.
What is the possible rootcause? short circuit? xbee failure?
Hope some one can share their experince.
thanks,
regards.
nahmad7245