Page 1 of 1

need some help in DIY automatic page turner

PostPosted: Sun Jun 23, 2013 12:34 pm
by ericklim6105
i need some helps in this project,i face some problem in using which suitable PIC microcontroller and which dc motor.

Re: need some help in DIY automatic page turner

PostPosted: Mon Jun 24, 2013 12:36 pm
by yonghui
how is the mechanism looks like?

Re: need some help in DIY automatic page turner

PostPosted: Thu Jun 27, 2013 8:48 pm
by ericklim6105
[youtube<iframe width="420" height="315" src="//www.youtube.com/embed/egbGiFzUxac" frameborder="0" allowfullscreen></iframe>][/youtube]
the product is some kind like this...i want do some modification on it. This prototype is just single turner arm. I want to modified it to become double turner arm instead to flip the pages forward and backward. It is using little suction to suck up the pages and the turner arm will flip the pages.
I would like to ask if possible to use PLC to program this prototype? because i am not familiar to pic.
can i use plc to program the pic microcontroller?

Re: need some help in DIY automatic page turner

PostPosted: Thu Jun 27, 2013 9:19 pm
by ericklim6105
can i know where to buy suitable small vacuum suction in malaysia´╝č