Cytron Technical Forum

Hi guys. I`ve been studying from PR 24 DIY circuit, and was wondering whether you can change the order of the two boxes below. Since from my point of view, i think it might not hurt if we put them in the wrong order, but i was curious of why does they put it in such order for the sensor and the v.resistor shows in the picture. Please help. Thanks in advanced

Oh my bad, it was actually PR 23, from here : http://www.cytron.com.my/viewProduct.php?pid=HiUfHBYMLSEqOzYhOCADPbr88qhInvC3IN/NjoX6QZU=&store=

Let just assume that i followed exactly like the schematic in my circuit for the above circuit, but i put the S1 > S4 and VR1 > VR4 (in the both red and blue boxes) in random. Would that be okay or it would affect the circuit? Sorry that i`m still new in reading circuit.

Anyone?

What do you mean by S1 > S4? in random? Give a specific example.

Do you mean you replace S1 with S4 and vise versa?

robosang WROTE:What do you mean by S1 > S4? in random? Give a specific example.

Do you mean you replace S1 with S4 and vise versa?

Yes, sorry i didn`t make it clearer in my previous post. Same goes to the order of VR1 until VR4

Yes, of course the sequence is important because the output of comparator will be connected to the microcontroller which read the sensor.

Thanks, i need that