Page 1 of 1

### Need help on DIY circuit

Posted: Mon Jul 22, 2013 2:49 am
Hi guys. I`ve been studying from PR 24 DIY circuit, and was wondering whether you can change the order of the two boxes below. Since from my point of view, i think it might not hurt if we put them in the wrong order, but i was curious of why does they put it in such order for the sensor and the v.resistor shows in the picture. Please help. Thanks in advanced

### Re: Need help on DIY circuit

Posted: Mon Jul 22, 2013 7:48 am
Not sure which project you referring to, but there are many ways to draw schematic

### Re: Need help on DIY circuit

Posted: Mon Jul 22, 2013 7:03 pm
Oh my bad, it was actually PR 23, from here : http://www.cytron.com.my/viewProduct.php?pid=HiUfHBYMLSEqOzYhOCADPbr88qhInvC3IN/NjoX6QZU=&store=

Let just assume that i followed exactly like the schematic in my circuit for the above circuit, but i put the S1 > S4 and VR1 > VR4 (in the both red and blue boxes) in random. Would that be okay or it would affect the circuit? Sorry that i`m still new in reading circuit.

### Re: Need help on DIY circuit

Posted: Wed Jul 24, 2013 6:18 pm
Anyone?

### Re: Need help on DIY circuit

Posted: Thu Jul 25, 2013 9:57 pm
What do you mean by S1 > S4? in random? Give a specific example.

Do you mean you replace S1 with S4 and vise versa?

### Re: Need help on DIY circuit

Posted: Fri Jul 26, 2013 6:53 am
robosang WROTE:What do you mean by S1 > S4? in random? Give a specific example.

Do you mean you replace S1 with S4 and vise versa?

Yes, sorry i didn`t make it clearer in my previous post. Same goes to the order of VR1 until VR4

### Re: Need help on DIY circuit

Posted: Sun Jul 28, 2013 9:18 pm
Yes, of course the sequence is important because the output of comparator will be connected to the microcontroller which read the sensor.

### Re: Need help on DIY circuit

Posted: Mon Jul 29, 2013 6:51 pm
Thanks, i need that