need help with SKPS. (Rx & Tx pin)

[wheresaly]

if we connect the SKPS with the PIC16 with UART function..

the wired from SKPS to the PIC should be cross connected rite?

ada voltage tak dkt TX and RX pin tu?

-newbie.

[shahrul]

You must understand UART signal. UART is digital, that is '0' and '1' or '0V and '5V'. It not constant voltage. The best to measure it using oscilloscope.

[wheresaly]

but i dont hv any oscilloscope with me.
what u mean is the signal is transmitted constantly rite?

the signal still transmitted even though we didn't press any button at the PS controller?

[shahrul]

but i dont hv any oscilloscope with me.
what u mean is the signal is transmitted constantly rite?

the signal still transmitted even though we didn't press any button at the PS controller?

Read the SKPS manual. SKPS will transmit data if SKPS receive a command. So, PIC need to transmit first to SKPS, then SKPS will transmit it's data. Ex SKPS.

[wheresaly]

ok trima kasih.
nnt sy try buat ye.
nnt sy rujuk dkt SKPS manual.

[gadgetng]

if we connect the SKPS with the PIC16 with UART function..

the wired from SKPS to the PIC should be cross connected rite?

ada voltage tak dkt TX and RX pin tu?

-newbie.

Yupe. Connect the RX to the TX and TX to RX.