Page 1 of 1
SN-M114 soil moisture sensor Info
Posted:
Thu May 16, 2013 12:16 amby khalid_khan
Hey ,
I would like to ask that what are the components we are using in the schematic of the pre-mentioned sensor's schematic diagram.
I want to interface it with Pic Microcontroller and want to simulate it in Proteus software. plz do let me know what are the components we r using .
Re: SN-M114 soil moisture sensor Info
Posted:
Thu May 16, 2013 9:19 pmby robosang
Can you paste the link of the product so forum member can easily get to the product? Not all of the members Cytron staff, OK?
Re: SN-M114 soil moisture sensor Info
Posted:
Fri May 17, 2013 3:35 amby khalid_khan
Re: SN-M114 soil moisture sensor Info
Posted:
Fri May 17, 2013 11:53 amby waiweng83
The Q1 in the schematic is just a generic NPN transistor. You can simulate it with any model.
Re: SN-M114 soil moisture sensor Info
Posted:
Fri May 17, 2013 11:16 pmby khalid_khan
and what is this pad1, pad2, con3 ???? I am not getting the schematic
Re: SN-M114 soil moisture sensor Info
Posted:
Fri May 17, 2013 11:20 pmby khalid_khan
Sir,
Actually i want to design the soil moisture sensor my self and this is the best sensor i can use for my project. In my project i have to interface it with PIC18f458 . so i need a proper circuit layout of this sensor
. i will b highly highly thankful to u
Re: SN-M114 soil moisture sensor Info
Posted:
Sat May 18, 2013 7:27 amby robosang
Obviously, you know nothing about schematic and product, and you do not take effort to understand it.
I do not have this sensor, but looking at the photo and understand the function of this sensor (it is meant to measure moisture), the pad 1 and pad 2 is the PCB track that extended out from the sensor where you "plug" into soil. Connector is the socket where you connect wires.
Think 1st! That is what engineers do!