Page 1 of 1

G15 Cube Servo

PostPosted: Sun Apr 22, 2018 5:00 pm
by Ravinath
hye. may i know what is the command in Arduino to stop the moving g15 cube servo?

Re: G15 Cube Servo

PostPosted: Wed Apr 25, 2018 9:04 am
by Idris
Hi Ravinath,

Did you manage to move the servo? If you able to move it, you should able to stop it.

Could you share a few clear photos/video of your hardware setup? Together with code you used.

Thanks.