Cytron Technical Forum

Hi all,

I need help with the Arduino BTBEE Shield Configuration

my operating system is windows 7 32/64 bit

I have tried the AT method in tutorial but i cant seem to get connect with the BTBee, any solutions or suggestions ?

Thanks in advance

You mean the BTBee does not response with "OK" after you sending "AT" to it? Make sure the setting is correct. The default baud rate for testing the module in AT command is 38400bps, instead of 9600. May i know how were you connect the BTBee to computer?

A photo of hardware setup is good, at least we know how is the hardware being connected. Hardware must be correct in order for software to function.

I'm connecting using Arduino + Xbee Shield + BTBee

operating system will be hyperterminal under win7 32bit

it shows Device is connected but i won't receive "OK" after i typed "AT"

You are using Arduino with this shield http://www.cytron.com.my/viewProduct.php?pcode=ARDUINO-XBEE&name=Arduino-XBee%20Shield%20(without%20module)??
IF it is, please:
1. There are two jumpers on the XBee shield, please set it to USB instead of XBee.
2. To be safe, plug out the IC ATMEGA from your arduino to avoid any interference. If you do not wish to take off the IC, please make sure the code in your IC does not use the TX and RX pin.

Now you should be able to receive "OK" after you sent the AT. Hope to hear from u ..

They are working perfectly now, looks like i didnt notice the jumper, pardon my foolishness

thank you very much.

philli3 WROTE:They are working perfectly now, looks like i didnt notice the jumper, pardon my foolishness

thank you very much.

Is OK to make mistake, just learn from your mistake. Good luck! Do share your project here. A photo and short description at here would be great to motivate other.