Zigbee+Adruino+motor

[HIIKIEWHUI]

Hi,
here i wanna to ask that is it the driver is need if i use the combination of Zigbee + Arduino Uno with the Minebea Stepping Motor ? Thanks

Regards

[robosang]

Sure need motor driver

[zhenning]

Yeah. You need a stepper motor driver

[HIIKIEWHUI]

Hi,
Is is possible that i get the drive to control the motor without the adruino?
Thanks

Regards

[zhenning]

Hi,
Is is possible that i get the drive to control the motor without the adruino?
Thanks

Regards

Yes you can. see this: http://www.simplecircuitdiagram.com/200 ... er-needed/

[HIIKIEWHUI]

Hi,

Thanks for the answer, i appreciate it.

Somethings that i am not clear is since i use one the Starter kit of my Zigbee connects to my computer as the transmitter and the other side the Zigbee chip is connected to the adruino and the motor by the expansion board as the receriver, does it works? As i use to program the microcontroller on the Arduino by using the software given, is it anything i need to do with my Zigbee?

Regards

[zhenning]

Hi,

Thanks for the answer, i appreciate it.

Somethings that i am not clear is since i use one the Starter kit of my Zigbee connects to my computer as the transmitter and the other side the Zigbee chip is connected to the adruino and the motor by the expansion board as the receriver, does it works? As i use to program the microcontroller on the Arduino by using the software given, is it anything i need to do with my Zigbee?

Regards

Hi,

You first need to program and configure your xbee: http://www.cytron.com.my/datasheet/Wire ... 20Test.pdf

Then, you can use your XBee as if its writing to uart or reading from uart.