Hi all frenz out there, need some comments..
I had an Arduino Uno + XBee Wifi + XBee Shield.
Firstly I had setup all three items above and it looks like a stack.
Curious 1
Can I program my XBee Wifi module by plug in Arduino UNO to my PC using UART ?? If can, then by using what method? X-CTU also?? Because I don wish to buy extra SKXBee just to program XBee Wifi.
Curious 2
Let said I had successfully configure XBee Wifi to connect to my home wireless network A. Then I unplug the Arduino Uno from my PC. Now I power up Arduino UNO by using external power source such as battery. And XBee Wifi is still together with XBee shield and Arduino UNO. Will XBee Wifi automatic connect to wireless network A after I power up Arduino UNO??
Curious 3
Let said XBee Wifi successfully connect to wireless network A. And I make my PC also connect to wireless network A. I had a push button on my Arduino System. When I press the button, can the signal send to PC through the wireless network A?? That mean send from microcontroller side to PC side through wireless network.
I not yet buy the XBee Wifi because I need to make sure it can be done before I buy it cause it was costly. I do not want to use XBee S1 or S2 as my project require me to connect to 802.11 b/g/n that is normal Wifi network.
If the above 3 problems that in my mind can be solved, then I will go for it.
Anybody please leave some comments here =) Please give some suggestion to me =) Any comments or corrections would be greatly appreciated!!