i never used xbee wifi before, but used xbee before.
i will like to know do u communicate with your xbee wifi? through UART or SPI.
TRansparent mode or API mode. if u are using transparent mode.
enter the AT command mode by +++ within one second. just dont put any delay between
then start entering your command followed by a CR (0x0D)
remember to read out the response from the Xbee "OK\r" 3 character from the module. every time u send something from UART>
refere product manual
http://www.cytron.com.my/usr_attachment ... Manual.pdfpage 25.