G15 Driver GD02 R2.0

Talk about Arduino board, sheilds. Sharing Arduino projects, program, problems, solutions, suggestions..... many more, all are welcome.

G15 Driver GD02 R2.0

Postby Ravinath » Sun Nov 19, 2017 7:48 pm

Hye. Im trying to run a G15 servo motor using GD02 R2.0 driver and arduino. but Im unable to make it run.im using Cytron-G15Shield-master library.can anyone help me??thanks

hye..im trying to run a G12 cube servo using Gd01 rev2.0 driver. when i upload the g15 library the motor is not functioning. connections i made:

G15DriverInit(19200,2,3,8);
arduino rx(2) --------connected to GD02 tx
arduino tx(3)---------connected to GD02 rx
arduino pin(8)--------connected to GD02 CTRL

thanks..
Ravinath
Newbie
 
Posts: 13
Joined: Sun Nov 19, 2017 4:14 pm

Re: G15 Driver GD02 R2.0

Postby Idris » Mon Nov 20, 2017 11:18 am

Hi Ravinath,

Could you share a few clear photos of your hardware setup?

Note: I have combine your previous post to this post.
Cytron Technologies invest time and resources providing tutorial, training and support for STEM education and maker movement. We need your support by purchasing products from Cytron Technologies. Thanks.
http://www.cytron.com.my
User avatar
Idris
Moderator
 
Posts: 384
Joined: Thu Mar 22, 2012 5:28 pm
Location: Pulau Pinang

Re: G15 Driver GD02 R2.0

Postby Ravinath » Thu Nov 30, 2017 6:37 pm

Idris WROTE:Hi Ravinath,

Could you share a few clear photos of your hardware setup?

Note: I have combine your previous post to this post.

hye..finally i made it..anyway thanks for your concern :)
Ravinath
Newbie
 
Posts: 13
Joined: Sun Nov 19, 2017 4:14 pm

Re: G15 Driver GD02 R2.0

Postby ober » Sun Dec 03, 2017 6:36 am

Good to hear that, mind to share what is the problem or mistake? I am sure others will benefit from your sharing.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1440
Joined: Wed Apr 15, 2009 1:03 pm

Re: G15 Driver GD02 R2.0

Postby Ravinath » Mon Dec 04, 2017 10:30 pm

ober WROTE:Good to hear that, mind to share what is the problem or mistake? I am sure others will benefit from your sharing.


Yeah initially I set the switch in B position in GD02 rev 2.0 driver.After I switch it to A then it starts to work. 8-)
Ravinath
Newbie
 
Posts: 13
Joined: Sun Nov 19, 2017 4:14 pm


Return to Arduino Based

Who is online

Users browsing this forum: No registered users and 5 guests

cron