Raspbery Pi I2C Address for HAT-MDD10?

Discussion about project that uses other controller, or non controller based project such as using logic gates, FPGA, ARM, Mechanical ....etc. Welcome to post it here

Raspbery Pi I2C Address for HAT-MDD10?

Postby msheald » Mon Mar 12, 2018 5:11 am

Hello! I purchased the HAT-MDD10 for my Raspberry Pi in order to control a couple of motors. I have several other items on the I2C bus.

Before I install it, I wanted to see what the default I2C address is and how to change the address if there is a conflict.

Thank you and best regards.

Mike
msheald
Greenhorn
 
Posts: 2
Joined: Mon Mar 12, 2018 5:07 am

Re: Raspbery Pi I2C Address for HAT-MDD10?

Postby ober » Mon Mar 12, 2018 6:14 am

There is no I2C address on HAT-MDD10, please do check the User's Manual

The DIR (Direction) and PWM (Speed) pins are tied to: Check page 5 of User's Manual
PWM1 tied to GPIO12
DIR1 tied to GPIO26
PWM2 tied to GPIO13
DIR2 tied to GPIO24

You can only use 1 HAT-MDD10 on a Raspberry Pi.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1352
Joined: Wed Apr 15, 2009 1:03 pm

Re: Raspbery Pi I2C Address for HAT-MDD10?

Postby msheald » Fri Mar 16, 2018 8:14 pm

Thank you!

Mike
msheald
Greenhorn
 
Posts: 2
Joined: Mon Mar 12, 2018 5:07 am


Return to Misc Project

Who is online

Users browsing this forum: No registered users and 1 guest

cron