Cytron Technical Forum

Hi Guys,

I have follow the following step from the link given. But the bootloader got error even the Red LED blinking after the SW press and release after the Reset Button. PLease help.

Message: Device not detected. Verify device is attached and in firmware update mode.

http://tutorial.cytron.com.my/2014/08/0 ... with-ciku/

Regards,
YY

Is the red LED is blinking after you try to enter bootloader mode? Could it be USB cable or connector problem? May be you can try with another cable and see how it goes.

Hi Kl84,

I just bought a new USB cable from shop. And then i plug in to my ciku usb female and i enter bootloader mode after i press SW (hold), press Reset and release SW button after release Reset. I think it should enter bootloader mode already. Is there any help?

Regards,
YY

Hi pikachuX,

Could you print screen the error message and share here?
Maybe, you can try with other computer. If still error, let us know.

Hi,

I had try it in another pc but still have an error which i already attach the picture below. Please take a look.

Regards,
YY

Hi pikachuX,

If you have UIC00B, you can try to re-download the CIKU bootloader to CIKU board using PICkit 2 software. You can find the bootloader file under CIKU product page here. But if you have difficulties to do that, or the error still exists, you can fill up this form. Our technical support team will follow up on your problem. You might need to return the product to Cytron Warranty Division for us verify the problem.