PCB Program

[ober]

Hi, I already downloaded this library but don't have this symbol for 2 pins push button. Did you get this symbol? if yes, can teach me how to add this?

Maybe you could create your own library for 2 pin push button? We are not familiar Eagle so cannot help much, sorry about that.

[TeoYX]

Do you know how to create own library? I still new in this software. If any experienced person know how to do, can please tell me?

Hope for your kindly help. Thanks a lot.

[zhenning]

Hi

I will need the details for the switch the best is if there is any datasheet.

[TeoYX]

Hi

I will need the details for the switch the best is if there is any datasheet.

Here is the component but don't have data sheet:

http://www.cytron.com.my/viewProduct.ph ... 202%20Pins

and

http://www.cytron.com.my/viewProduct.ph ... h%28PCB%29

can you please teach me how to create own library for these items?

[zhenning]

the 2nd switch you can just replace them with header pins, it should fit

[zhenning]

Hi,

Since

ramaking 2010-10-11 06:47:53
what is dimension between leg..can mount into pcb?
Admin Reply :
Hi, the leg distance is 200mil (5.08mm). is can fit into standard strip board.

Then, you should be able to use header to represent it too. Unless you want the trouble to create them XD

[TeoYX]

hehe, i still don't know how to create own library. Do you have this library for the 2 pin button already? Can please send one copy for me?

[zhenning]

hehe, i still don't know how to create own library. Do you have this library for the 2 pin button already? Can please send one copy for me?

Try this out. Not sure if its right as i dont have the full dimension except the distance between the pins

[TeoYX]

Thanks zhenning.

[zhenning]

Thanks zhenning.

Welcome