Page 1 of 3

PCB Program

PostPosted: Wed Sep 14, 2011 6:13 pm
by TeoYX
Hi all,


Anyone familiar with Eagle software (PCB Schematic Layout program)? Do you know what is the symbol for the battery holder?

Hope somebody can help on this. Thanks a lot in advance.


From,
Teo YX

Re: PCB Program

PostPosted: Thu Sep 15, 2011 3:27 pm
by hyng
Sorry.. nvr use b4. But i found one of the thousands tutorial in website..

http://www.sparkfun.com/tutorials/108

Hope it will help u. ;)

Re: PCB Program

PostPosted: Fri Sep 16, 2011 9:17 am
by TeoYX
OK, thanks.

Does anyone know how to do this too? Hope can get some suggestions. Thanks a lot.

Re: PCB Program

PostPosted: Fri Sep 16, 2011 11:45 am
by Brian Griffin
I have used a bit. Have you checked the Instructables tutorial? They have a couple of tutorials of designing PCB using Eagle. :)

Re: PCB Program

PostPosted: Sun Sep 18, 2011 8:41 am
by TeoYX
Hi all,


ya, i also found the tutorials, however, there is no library for that? Does anyone have the Eagle library for the "adapter socket" and "push button switch"?

Please help if you know where to download or if you have, please pm to me, i will provide you my email.

Thanks a lot.


From,
Teo

Re: PCB Program

PostPosted: Mon Sep 19, 2011 1:46 pm
by sich
Hi Teo,

I've created a new forum for "PCB Design" and your post has been removed to this forum.

About your question, you can search for Sparkfun's Eagle library online. They open the library for download somewhere out there. The components you want should be available in their library. Have a try.

Re: PCB Program

PostPosted: Mon Sep 19, 2011 10:14 pm
by TeoYX
ok, i will go there to try it. Thanks a lot.

Re: PCB Program

PostPosted: Fri Sep 30, 2011 12:17 am
by TeoYX
hi,


I am using the PR25 and doing the PCB schematic diagram. However, i found that there is no symbol for Push Button from the library which you recommended. It is 2 pins only. Does anyone know the symbol for Push Button? If yes, can send me this part library only?

Hope can get your help. Thanks a lot.

Re: PCB Program

PostPosted: Fri Sep 30, 2011 3:45 pm
by zhenning
Hi,

Grab the sparkfun library and add it to the eagle libraries:

http://www.opencircuits.com/SFE_Footprint_Library_Eagle

it will add more footprint and symbols. Most likely you would find the one you need here :)

Re: PCB Program

PostPosted: Fri Sep 30, 2011 5:18 pm
by TeoYX
Hi, I already downloaded this library but don't have this symbol for 2 pins push button. Did you get this symbol? if yes, can teach me how to add this?

Thanks a lot.