Page 1 of 1

Arduino and sensor libraries for Eagle

PostPosted: Fri Feb 21, 2014 12:26 pm
by tan tai pinn
Hi, I would like to know if it is possible to get the libraries in Eagle for the components bought from Cytron. I would only want the dimensions of the drilling holes so that I can drill the acrylic sheet accurately to attach the Arduino and other sensors bought from Cytron, namely the IMU and infrared sensor. Or is there any other software where there are available libraries? Thank you very much this is for my FYP.

Re: Arduino and sensor libraries for Eagle

PostPosted: Fri Feb 21, 2014 2:18 pm
by yonghui
i think cytron did not provide eagle footprint. but i think most product has the dimension specifications in the user manual or dedicated dimension document to show the accurate information for the footprint. You can draw your footprint according to the document. for the IR sensor, if it is 5mm IR i think the footprint should be same as 5mm normal LED.

Re: Arduino and sensor libraries for Eagle

PostPosted: Mon Feb 24, 2014 11:36 am
by tan tai pinn
Thank you for your reply! have a nice day!! :D