SmartDriveDuo 10A to 6 channels RC controller
Posted: Fri Jul 07, 2017 10:13 pm
I am planning to build a 4-wheeled rover with your SmartDriveDuo-10A and controlled by a 6 channels RC controller (Mode 2).
My questions are;
1. is my project possible?
I am planning to connect 2 motors in parallel to each side of motor driver.
2. which channel of my receiver should I connect the RC1 and RC2 of your MDDS-10A?
I have tried to set up as above, but the output to the motor left and right are not at the same speed because the output voltage of right and left channels is different by half.
Why? How to Correct it?
My questions are;
1. is my project possible?
I am planning to connect 2 motors in parallel to each side of motor driver.
2. which channel of my receiver should I connect the RC1 and RC2 of your MDDS-10A?
I have tried to set up as above, but the output to the motor left and right are not at the same speed because the output voltage of right and left channels is different by half.
Why? How to Correct it?