Page 1 of 1

Display Text Message on Dot Matrix, Blynk not working

PostPosted: Thu Mar 21, 2019 12:48 pm
by wilsonl
Dear experts,

Actually i am started learning and following the tutorials by cytron. Currently i am learning on DISPLAYING TEXT MESSAGE ON DOT MATRIX USING BLYNK AND ARDUINO.

So far no issue for ESP8266 Wifi shield and Uno maker. Everything works well , I have the output text of Cytron Technologies Blynk Ready on dot matrix. Blynk also connected. However, the I am trying to input text on the Blynk App - Text Input . I did not get any output display on the Dotmatrix. Is it I have missed out any settings on the blynk input text setting?
Hope can get some advice from you all.

Re: Display Text Message on Dot Matrix, Blynk not working

PostPosted: Thu Mar 21, 2019 5:42 pm
by Idris
Hi wilsonl,

Could you double check on your virtual pins between Blynk and programming is same?

Re: Display Text Message on Dot Matrix, Blynk not working

PostPosted: Sat Mar 23, 2019 3:25 pm
by wilsonl
HI idris ,

Thanks for the wonderful guide. Yes i manage to solve it. Thanks a lot.

For others who might be facing this simple issue, set the virtual for your Blynk text field to V0 :)