Programming ESP8266 on Cytron WiFi Shield
Posted: Mon May 22, 2017 1:36 pm
Hi,
How can i write the code or firmware over ESP8266 (module on cytron shield) itself, through Arduino IDE, rather than writing the code only on base board like Arduino Uno or Arduino Mega?
We need to have two different codes, one on the Cytron ESP8266 shield and one on the Arduino Mega board.
I need to know the hardware configuration and the programming interface, as I could not find any programming interface on the Cytron Shield.
As per your last reply, you said we can use UC00A/UC00C or other USB-Serial adapter to do so. But there are no pinouts (DTR, CT, VSEL, etc.) to be seen on the board.
Can you please explain how to program?
Or how to program inside ESP8266 via Arduino Mega 2560?
How can i write the code or firmware over ESP8266 (module on cytron shield) itself, through Arduino IDE, rather than writing the code only on base board like Arduino Uno or Arduino Mega?
We need to have two different codes, one on the Cytron ESP8266 shield and one on the Arduino Mega board.
I need to know the hardware configuration and the programming interface, as I could not find any programming interface on the Cytron Shield.
As per your last reply, you said we can use UC00A/UC00C or other USB-Serial adapter to do so. But there are no pinouts (DTR, CT, VSEL, etc.) to be seen on the board.
Can you please explain how to program?
Or how to program inside ESP8266 via Arduino Mega 2560?