AT command on ESP8266 on Cytron WiFi Shield

Discussion on how to get started with various type of IoT projects

AT command on ESP8266 on Cytron WiFi Shield

Postby chinskoon1 » Wed Jul 05, 2017 9:55 am

Hi
Anyone please advise how program the ESP8266 Cytron WiFi Shield to become response to AT command?

Thanks
chinskoon1
Fledgling
 
Posts: 1
Joined: Wed Jul 05, 2017 9:45 am

Re: AT command on ESP8266 on Cytron WiFi Shield

Postby bengchet » Thu Jul 06, 2017 4:37 pm

Hi,

Please refer to here page 15 (Install AT firmware).

To allow ESPresso Lite to enter flash mode,

1) Attach ESPresso Lite to UC00C(or any other USB-UART converter) but left DTR unconnected (you can bend the DTR pin leg on ESPresso Lite slightly so that it wont connected to DTR pin of UC00C).

2) While holding GPIO0 button, press RESET button to reset it. ESPresso Lite should enter Flash mode by now. Then you can continue the steps mentioned from link above.
bengchet
Moderator
 
Posts: 237
Joined: Tue Aug 25, 2015 8:29 am


Return to Getting Started - IoT

Who is online

Users browsing this forum: No registered users and 11 guests

cron