IFC for both 12V and 24V motor
Posted: Fri Dec 09, 2011 10:02 am
Hi,
Good day~
I having IFC card of MainBrain, PowerCard, Control Panel, Dual Brush Motor, Brushless Motor card,
i need to drive two motors:
1) one 12V brush motor with Dual Brush Motor Card,
2) one 24V brushless motor (with driver) with Brushless Motor Card
A) i need to use power supply (instead of battery) to power up those cards and motors. Thus i guess i cant supply two 12V supply to the power card to built up a 24V supply using my power supply where th two 12V supply sharing the same GND, am i right?
B) i guess i cant use one single 24V supply to the power card and use the External supply out to supply to External supply in of 12V to power up the 12V brush motor as well, because i didnt see any regulator to regulate the 24V to 12V from the schematic in the power card? am i right? or i can still do that?
C) so i think i left the option of supply 12V to power card, use External supply out to External supply in to power my 12V brush motor. Then for the 24V brushless motor, i will use external 12V power supply from my power supply unit, do u think this work? and use the jumper on the brushless motor card to select external supply?
D) i am bit confuse with the power supply circuit of the power card and how those jumper select the voltage supply as there is no reference designator on the card and thus difficult to trace with the schematic and i lack of knowledge on this. Appreciate if can advise or explain a bit on the schematic.
Pls advise and thanks
Good day~
I having IFC card of MainBrain, PowerCard, Control Panel, Dual Brush Motor, Brushless Motor card,
i need to drive two motors:
1) one 12V brush motor with Dual Brush Motor Card,
2) one 24V brushless motor (with driver) with Brushless Motor Card
A) i need to use power supply (instead of battery) to power up those cards and motors. Thus i guess i cant supply two 12V supply to the power card to built up a 24V supply using my power supply where th two 12V supply sharing the same GND, am i right?
B) i guess i cant use one single 24V supply to the power card and use the External supply out to supply to External supply in of 12V to power up the 12V brush motor as well, because i didnt see any regulator to regulate the 24V to 12V from the schematic in the power card? am i right? or i can still do that?
C) so i think i left the option of supply 12V to power card, use External supply out to External supply in to power my 12V brush motor. Then for the 24V brushless motor, i will use external 12V power supply from my power supply unit, do u think this work? and use the jumper on the brushless motor card to select external supply?
D) i am bit confuse with the power supply circuit of the power card and how those jumper select the voltage supply as there is no reference designator on the card and thus difficult to trace with the schematic and i lack of knowledge on this. Appreciate if can advise or explain a bit on the schematic.
Pls advise and thanks