Page 2 of 2
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Thu May 12, 2016 11:02 am
by ober
Have you check the data from LSA using computer?
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Thu May 12, 2016 1:58 pm
by Kalman
The data from LSA08 to computer is correct.
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Thu May 12, 2016 5:16 pm
by ober
If the data from LSA08 to computer is correct, then it will be the program on STM, right?
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Fri May 13, 2016 1:32 am
by Kalman
Yes, I think the LSA08 is working fine. So, I will try to troubleshoot my coding. Thanks for your advice.
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Fri May 13, 2016 8:32 am
by ober
I believe the bugs is in the printf function. Try playing with that.
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Sat May 14, 2016 8:16 am
by Kalman
The problem had been solved last night, it is due to I didn't connect both STM32 and LSA08 to common ground. Thanks for your help.
Re: Advanced Auto-Calibrating Line Sensor_SLA08
Posted:
Sun May 15, 2016 10:32 pm
by ober
Good to hear that, do share the actual hardware setup photo