Page 1 of 1

sensor 5 dof imu

PostPosted: Sun Mar 13, 2016 12:01 pm
by hendrifauzam
can anyone help me how to connect this sensor to arduino UNO and motor driver ?

Re: sensor 5 dof imu

PostPosted: Mon Mar 14, 2016 4:08 pm
by ZaM
Connection would not be difficult, but using it will take some understanding and work. As the output of this sensor is analog, you can simply connect to Arduino UNO's analog input pins, which is A0 to A5, any pin would do the works. As for motor driver, you can use 2A motor shield which does not need manual interface, just stack it on to Arduino UNO. The part where you need to study and try is software, which combine the input signal of IMU and control the driver :)

sensor 5 dof imu Humidity requirements

PostPosted: Fri Nov 24, 2017 10:47 am
by kennylim
Hi,

I'm designing something to include this IMU for long term use
I searched the datasheets and did not find RH humidity requirements.
The closest i got was the following for Gyro sensors
"Also avoid exposure to moisture. Store the products
where the temperature and relative humidity do not
exceed 5 to 40°C and 20 to 75%R.H. Srore the
products in a sealed bag and use with in 6 months."

Need help to find out the RH operating and storage conditions

regards,
Kenny

Re: sensor 5 dof imu

PostPosted: Sun Nov 26, 2017 6:41 am
by ober
Well, if the datasheet does not state it, we do not know too.