I am planning to do a electric scooter project using this MD30C controller. Here are some of my question before i purchase from Cytron:
1. Can i use the potentiometer to control the motor speed of the 24V 350watt DC motor that i purchase from Cytron?
2. if the potentiometer can be use to control the motor speed, will it run smoothly?
3. I use 2 12V car battery as my power supply, should i solder the wire to the pad at the bottom layer of the MD30C?
4. The 24V 350W motor that i purchase from Cytron also need to solder to the pad at the bottom layer of the MD30C?
5. The external potentiometer that i use also need to be soldered?