MD30C project box
Posted: Fri Dec 15, 2017 2:51 am
Hi All, Im new here, I hope ive posted in the correct section,
Ive just taken delivery of my MD30C controller board and have a few questions.
I want to mount the controller in a plastic project box, on the box I would like to put the switches, pot and led's, can someone please tell me:
What value pot do I need.
What are the best LED's to use and also what way to connect them to the board,
anode cathode, positive, negative.
Will the controller work OK with a 5 volt supply and drive a 5 volt motor
And last, Ive not tested yet, I assume the controller is ground side switched
Thanks
Thanks
Ive just taken delivery of my MD30C controller board and have a few questions.
I want to mount the controller in a plastic project box, on the box I would like to put the switches, pot and led's, can someone please tell me:
What value pot do I need.
What are the best LED's to use and also what way to connect them to the board,
anode cathode, positive, negative.
Will the controller work OK with a 5 volt supply and drive a 5 volt motor
And last, Ive not tested yet, I assume the controller is ground side switched
Thanks
Thanks