connect 2A Motor Driver Shield to Arduino Mega

Autonomous Robot, Manual Robot, DC Motor Driver, Stepper Motor Driver, Servo, Multi PWM chip.....

connect 2A Motor Driver Shield to Arduino Mega

Postby alex1 » Thu Jun 20, 2019 4:27 am

Hi
I tried to connect 2A Motor Driver Shield to Arduino Mega through the wires, but it is not working.
4 jumpers are connected to the Signed Magnitude pins and I connect the 4 pins of Arduino mega (5,4,6,7) to the Signed Magnitude pins and I change VIN pin to the PWERIN pin, but it is not working. how can I overcome this problem, I use samples code from following URL
https://github.com/CytronTechnologies/C ... eld2AMotor
alex1
Fledgling
 
Posts: 1
Joined: Thu Jun 20, 2019 4:12 am

Re: connect 2A Motor Driver Shield to Arduino Mega

Postby ober » Thu Jun 20, 2019 4:56 am

Mind showing the actual hardware wiring and setup? Have you connected the 5V and GND?
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1486
Joined: Wed Apr 15, 2009 1:03 pm


Return to Robot Controller

Who is online

Users browsing this forum: No registered users and 22 guests