MDDS30 NC pin on PWM and Serial connections

Autonomous Robot, Manual Robot, DC Motor Driver, Stepper Motor Driver, Servo, Multi PWM chip.....

MDDS30 NC pin on PWM and Serial connections

Postby john sampson » Mon Jul 29, 2019 10:55 am

I have searched and cannot find any mention of the NC pins in the documentation.

I assume this pin is labeled NC for not connected. Is that the case?

Should i just leave it floating in PWM or Serial mode?

Is it a 5v connection?

Is there a reason the included grove connectors have a red wire for this pin?

Thanks-
john sampson
Fledgling
 
Posts: 1
Joined: Mon Jul 29, 2019 10:48 am

Re: MDDS30 NC pin on PWM and Serial connections

Postby ober » Tue Jul 30, 2019 6:16 am

Hi, I believe you are referring to the "NC" on Grove connector.

Yup, NC refer to "Not Connected".

We will update the User's Manual to indicate that.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1486
Joined: Wed Apr 15, 2009 1:03 pm


Return to Robot Controller

Who is online

Users browsing this forum: No registered users and 15 guests

cron