Page 1 of 1

about GUI sofware SC16A

PostPosted: Wed Dec 09, 2009 9:51 pm
by keybord34
i want know.. if i want set position servo motor1= 40 degree. i only drag the corresponding sliding bar. if i want change position servo motor1 40 degree to 145 degree or 175 degree to 10 degree .. do i only need drag corresponding to??

Re: about GUI sofware SC16A

PostPosted: Thu Dec 10, 2009 4:53 pm
by hyng
Yes,.... if you are using the GUI provided. ;)

Re: about GUI sofware SC16A

PostPosted: Fri Dec 11, 2009 10:17 am
by keybord34
if i want use own GUI sofware,what should I do?

Re: about GUI sofware SC16A

PostPosted: Fri Dec 11, 2009 1:40 pm
by sich
Study the communication protocol to control the driver. You need to refer to SC16A user's manual.