what is the warning means?

[cpleng7]

Warning: No configuration word in hex file.
In Mplab use File-Export to save hex with config

[yonghui]

hi,

not sure,

but make sure u set the configuration words, either in code or from the configuration bits setting of the MPLAB



rgrds,
yh

[shiyan]

Warning: No configuration word in hex file.
In Mplab use File-Export to save hex with config

Where did you get this warning?

[happyrush]

Hi,

If i am not wrong this warning is on PICKIT2 during you import the Hex file.

It means that your Hex file does not consist the configuration parameter, when you loaded in, your controller cannot function or cannot function properly.

During Hex file export in the MPLAB,you must tick the configuration bit option.