mdd10a DIR1 problem

LINIX Brushless, VEXTA Brushless, RC Servo, DC Geared, Linear, Stepper, Tamiya.....

mdd10a DIR1 problem

Postby alhmma » Mon Oct 29, 2018 12:20 am

i have problem with my mdd10a rev 2.0 dir1 pin
when i press the cross button on my ps4 button it doesn't move the motor
i measure the voltage m1a it draw less then the others (m1b, m2a and m2b)
the motor work fine when manually tested and my ps4 controller

Code: Select all
#include <PS4BT.h>
#include <usbhub.h>
#ifdef dobogusinclude
#include <spi4teensy3.h>
#endif
#include <SPI.h>

USB Usb;

BTD Btd(&Usb);

PS4BT PS4(&Btd, PAIR);

#define dir_1 5
#define pwm_1 6
#define dir_2 8
#define pwm_2 9

void setup() {
  Serial.begin(115200);
  while (!Serial); // Wait for serial port to connect - used on Leonardo, Teensy and other boards with built-in USB CDC serial connection
  if (Usb.Init() == -1) {
    Serial.print(F("\r\nOSC did not start"));
    while (1); // Halt
    }
    Serial.print(F("\r\nPS4 Bluetooth Library Started"));

  pinMode(dir_1, OUTPUT);
  pinMode(pwm_1, OUTPUT);
  pinMode(dir_1, OUTPUT);
  pinMode(pwm_2, OUTPUT);

}

void loop() {
  Usb.Task();

  if(PS4.connected()){

    Serial.print(F("\nPS4 connected"));

    if(PS4.getButtonPress(CROSS)){

      analogWrite(pwm_1, 100);
      digitalWrite(dir_1, LOW);
     
    }
    if(PS4.getButtonPress(TRIANGLE)){

      analogWrite(pwm_1, 150);
      digitalWrite(dir_1, HIGH);
     
    }
    else {

      analogWrite(pwm_1, 0);
      analogWrite(pwm_2, 0);

    }
    if(PS4.getButtonPress(UP)){

      analogWrite(pwm_2, 150);
      digitalWrite(dir_2, HIGH);
     
    }
    if(PS4.getButtonPress(DOWN)){

      analogWrite(pwm_2, 150);
      digitalWrite(dir_2, LOW);
     
    }
    if (PS4.getButtonClick(PS)) {
      Serial.print(F("\r\nPS disconnected"));
      PS4.disconnect();
      Serial.end();
     
    }
  }
}
alhmma
Greenhorn
 
Posts: 2
Joined: Sun Oct 28, 2018 12:38 am

Re: mdd10a DIR1 problem

Postby ober » Wed Oct 31, 2018 6:54 am

Well, I do not check code :D because I am not compiler.

We need more information to identify where the problem is. It might be connection, it might code too. Can you show us the actual hardware connection in detailed? Capture a few clear photos and share here.
Ober Choo
Cytron Technologies Sdn Bhd
www.cytron.com.my
User avatar
ober
Moderator
 
Posts: 1378
Joined: Wed Apr 15, 2009 1:03 pm


Return to DC Motor

Who is online

Users browsing this forum: No registered users and 1 guest