MD13S err on "rapid" change in pulse width?

LINIX Brushless, VEXTA Brushless, RC Servo, DC Geared, Linear, Stepper, Tamiya.....

MD13S err on "rapid" change in pulse width?

Postby drlove » Tue Dec 19, 2023 6:41 pm

[SOLVED]
There was some interference between my current measuring board (INA219) and the MD13S board, after moving it to before the MD13S-board all is working great!

Hi,

We just received the MD13S that we use with a continuously rotating windshield wiper motor (12v, 2A, brushless).

When starting from 0% PW and increasing the motor sounds really bad and the Err LED is blinking.
When cranking it up to 100% the motor runs OK and no Err LED.
When slowly lowering PW from 100% everything is OK but if we do a rapid decrease/increase in PW the motor starts to sound bad and Err LED is flashing again.

What could be wrong?
drlove
Fledgling
 
Posts: 1
Joined: Tue Dec 19, 2023 6:38 pm

Re: MD13S err on "rapid" change in pulse width?

Postby waiweng83 » Mon Apr 22, 2024 6:45 pm

Hi,

Are you powering up the motor from a switching power supply? Does it able to support the inrush current needed by the motor during acceleration?
With the power of dream, nothing is impossible...
User avatar
waiweng83
Moderator
 
Posts: 208
Joined: Wed Apr 15, 2009 2:17 pm


Return to DC Motor

Who is online

Users browsing this forum: No registered users and 4 guests

cron