robosang WROTE:You need to let us know what are you using, PICkit2? UIC00B? ICD2? ICD3? How is the connection, what is the result? etc.... How can we help without those information?
Thank you very much for your response.
I am using PICkit2 and UIC00B. The connection i did as it is suggested in the manual of these products.
So I think there is no problem with hardware connections. When I compile Software is also building the program successfully and I was just testing the LED on/off program and motor shaft rotates program using the code from cytron website.
But neither the LED on/off nor Motor rotational program is giving output result even though after running the program there is no error.
I would like to know the main point such as:
How can I know that the program donloaded successfully I mean to check the memory of the PIC?
I also get the follwoing message after compilation:
Found PICkit 2 - Operating System Version 2.32.0
PICkit 2 Unit ID = UIC00B V1.0
Target power not detected - Powering from PICkit 2 ( 5.00V)
PIC16F877A found (Rev 0x8)
PICkit 2 Readyif I change the settings then I get following message:
Initializing PICkit 2 version 0.0.3.63
Found PICkit 2 - Operating System Version 2.32.0
PICkit 2 Unit ID = UIC00B V1.0
PICkit 2 Settings: Using target power always.
PK2Error0023: Target Vdd measured at 0.00V which is outside the programmable range of this device ( 4.50V - 5.50V)
PICkit 2 Ready
How can i get the target power and what is the target power in this case?
Thank you very much again.