MD13S - How to connect shunt regulator?

LINIX Brushless, VEXTA Brushless, RC Servo, DC Geared, Linear, Stepper, Tamiya.....

MD13S - How to connect shunt regulator?

Postby mikemelga » Wed Mar 17, 2021 9:58 pm

Hi everyone.

Let me start by saying that I have very little electronics knowledge.

I am building a motion enabled racing rig and I am using the following:

Arduino Uno
24v 220w DC Brushless Motor
Cytron MD13S (one each motor)
Meanwell Power Supply (LRS-350-24) 24v 14.6A (one each motor)
Polulu 3775 Shunt Regulator 26.4v 2.80 15w (one each motor) (I was told I needed this)


My question is:

How exactly do I connect the shunt regulator? Shall I connect it like the picture shows?
If so, what fuse value should I use?

Thanks.
Attachments
shunt_regulator.jpg
mikemelga
Greenhorn
 
Posts: 2
Joined: Wed Mar 17, 2021 7:20 pm

Re: MD13S - How to connect shunt regulator?

Postby waiweng83 » Thu Mar 18, 2021 2:39 pm

Yes, you can connect the shunt regulator according to the diagram you posted.
The fuse and diode is optional. If you wish to connect a fuse, 15A is a good start.
With the power of dream, nothing is impossible...
User avatar
waiweng83
Moderator
 
Posts: 189
Joined: Wed Apr 15, 2009 2:17 pm

Re: MD13S - How to connect shunt regulator?

Postby mikemelga » Thu Mar 18, 2021 5:56 pm

Thanks!
mikemelga
Greenhorn
 
Posts: 2
Joined: Wed Mar 17, 2021 7:20 pm


Return to DC Motor

Who is online

Users browsing this forum: No registered users and 1 guest

cron